Dimensions: 4150 * 2140 * 1756

Power: Hydraulic station motor 11KW, turntable motor 2.2KW

Hydraulic top: 2 sets of Φ cylinder diameter 140, stroke 500mm

Squeezing plate: 16mm (thickness) * 1200mm (height)

Total weight of equipment: 3900kg

Hydraulic station dimensions, length 750 x width 600 x height 560mm

Bottom turntable with a diameter of 1300mm and a thickness of 16mm

The minimum diameter for no-load operation is 900mm, and the maximum opening diameter is 1800mm

Hydraulic output pressure 0-20MPa (recommended working pressure<16MPA)

Synchronous splitter: 15 diameter

Introduction:

With the popularization of electronic metering ingredients in compound fertilizer production, raw material suppliers are increasingly using ton packaging for ammonium chloride and ammonium phosphate. However, the agglomeration of ton packaging raw materials affects electronic metering ingredients and must be crushed and loosened first. The double cylinder ton pack material loosening machine was developed to solve this problem. Adopting electronic remote control and hydraulic technology. It has the characteristics of simple structure, easy operation, and good extrusion effect. The total weight of the equipment is that the double bar extruder has a higher power, higher thickness and height, more hydraulic cylinders, and better and more comprehensive extrusion effect compared to ordinary extruders.

usage method

Place the equipment flat in a certain position in the workshop (without the need for a foundation, with a ground bearing capacity of 5 tons per square meter), connect it to the power supply, and it can be used. Supporting equipment such as cranes or shovels.

This equipment undergoes strict debugging and pressure testing before leaving the factory, and must be filled with 46 # hydraulic oil before starting up.

Before starting up, connect the power supply according to the wiring diagram, using manual or remote control. The operator lifts the ton of raw materials with a shovel and places them on the middle platform between the two curved plates of the extruder. Press the remote control compression button, and the hydraulic cylinder slowly clamps the two curved plates. After loosening the material clamp, press the release button to slowly release the curved plate. If the clumping is not very severe, it can be done once.

If the agglomeration is severe, start the turntable to rotate multiple angles and squeeze multiple times until the effect is achieved.